Posts Tagged "fused deposition modeling"

This post was originally created on December 8, 2016.

With all the buzz about Additive Manufacturing, or 3D Printing, in the manufacturing world today, there is a lot of mystery and confusion surrounding common practices and techniques. This week’s blog post will address a common type of 3D printing known as Fused Deposition Modeling (FDM).

But first, What is Additive Manufacturing?

Additive manufacturing is the process of creating a part by laying down a series of successive cross-sections (a 2D “sliced” section of a part). It came into the manufacturing world about 35 years ago in the early 1980s, and was adapted more widely later in the decade. Another common term used to describe additive manufacturing is 3D Printing – a term which originally referred to a specific process, but is now used to describe all similar technologies.

Now that we’ve covered the basics of 3D Printing, What is Fused Deposition Modeling?

It is actually part of a broader category, commonly referred to as a Filament Extrusion Techniques.  Filament extrusion techniques all utilize a thin filament or wire of material. The material, typically a thermoplastic polymer, is forced through a heating element, and is extruded out in 2D cross section on a platform. The platform is lowered and the process is repeated until a part is completed. In most commercial machines, and higher-end consumer grade machines, the build area is typically kept at an elevated temperature to prevent part defects (more on this later). The most common form, and the first technology of this type to be developed, is FDM.

The Fused Deposition Modeling Technique was developed by S. Scott Crump, co-founder of Stratasys, Ltd. in the late 1980s. The technology was then patented in 1989. The patent for FDM expired in the early 2000s. This helped to give rise to the Maker movement, by allowing other companies to commercialize the technology.

It should also be noted that Fused Deposition Modeling is also known as Fused Filament Fabrication, or FFF. This term was coined by the Reprap community, because Stratasys has a trademark on Fused Deposition Modeling.

What Are the Advantages of this Process? […]

© Tata Technologies 2009-2015. All rights reserved.